# 3.1: Schrödinger Equation of Motion

Up to now, we have only considered systems at one particular instant of time. Let us now investigate the time evolution if quantum mechanical systems.

Consider a system in a state \(A\) that evolves in time. At time \(t\) , the state of the system is represented by the ket \(\vert At\rangle\) . The label \(A\) is needed to distinguish this ket from any other ket ( \(\vert Bt\rangle\) , say) that is evolving in time. The label \(t\) is needed to distinguish the different states of the system at different times.

The final state of the system at time \(t\) is completely determined by its initial state at time \(t_0\) plus the time interval \(t-t_0\) (assuming that the system is left undisturbed during this time interval). However, the final state only determines the *direction* of the final state ket. Even if we adopt the convention that all state kets have unit norms, the final ket is still not completely determined, because it can be multiplied by an arbitrary phase-factor. However, we expect that if a superposition relation holds for certain states at time \(t_0\) then the same relation should hold between the corresponding time-evolved states at time \(t\) , assuming that the system is left undisturbed between times \(t_0\) and \(t\) . In other words, if

(220) |

for any three kets then we should have

(221) |

This rule determines the time-evolved kets to within a single arbitrary phase-factor to be multiplied into all of them. The evolved kets cannot be multiplied by individual phase-factors because this would invalidate the superposition relation at later times.

According to Equations (220) and (221), the final ket depends linearly on the initial ket . Thus, the final ket can be regarded as the result of some linear operator acting on the initial ket: i.e.,

where \(T\) is a linear operator that depends only on the times and . The arbitrary phase-factor by which all time-evolved kets may be multiplied results in being undetermined to an arbitrary multiplicative constant of modulus unity.

Because we have adopted a convention in which the norm of any state ket is unity, it make sense to define the time evolution operator \(T\) in such a manner that it preserves the length of any ket upon which it acts (i.e., if a ket is properly normalized at time \(t\) then it will remain normalized at all subsequent times ). This is always possible, because the length of a ket possesses no physical significance. Thus, we require that

(223) |

for any ket \(T\) , which immediately yields

Hence, the time evolution operator \(T\) is *unitary*.

Up to now, the time evolution operator \(T\) looks very much like the spatial displacement operator \(D\) introduced in the previous section. However, there are some important differences between time evolution and spatial displacement. In general, we *do* expect the expectation value of some observable to evolve with time, even if the system is left in a state of undisturbed motion (after all, time evolution has no meaning unless something *observable* changes with time). The triple product can evolve either because the ket evolves and the operator stays constant, the ket stays constant and the operator evolves, or both the ket and the operator evolve. Because we are already committed to evolving state kets, according to Equation (222), let us assume that the time evolution operator \(T\) can be chosen in such a manner that the operators representing the dynamical variables of the system *do not* evolve in time (unless they contain some specific time dependence).

We expect, from physical continuity, that if then for any ket . Thus, the limit

should exist. Note that this limit is simply the derivative of with respect to . Let

(226) |

It is easily demonstrated from Equation (224) that is anti-Hermitian: i.e.,

(227) |

The fact that can be replaced by (where is real) implies that is undetermined to an arbitrary *imaginary* additive constant (see Section 2.8). Let us define the Hermitian operator . This operator is undetermined to an arbitrary *real* additive constant. It follows from Equations (225) and (226) that

(228) |

When written for general \(t\) , this equation becomes

(229) |

Equation (229) gives the general law for the time evolution of a state ket in a scheme in which the operators representing the dynamical variables remain fixed. This equation is denoted the *Schrödinger equation of motion*. It involves a Hermitian operator which is, presumably, a characteristic of the dynamical system under investigation.

We saw, in Section 2.8, that if the operator displaces the system along the -axis from to then

(230) |

where is the operator representing the momentum conjugate to \(x\) . Furthermore, we have just shown that if the operator evolves the system in time from to then

(231) |

Thus, the dynamical variable corresponding to the operator stands to time as the momentum stands to the coordinate \(x\) . By analogy with classical physics, this suggests that is the operator representing the total *energy* of the system. (Recall that, in classical physics, if the equations of motion of a system are invariant under an \(x\)-displacement of the system then this implies that the system conserves momentum in the \(x\)-direction. Likewise, if the equations of motion are invariant under a temporal displacement then this implies that the system conserves energy.) The operator is usually called the *Hamiltonian* of the system. The fact that the Hamiltonian is undetermined to an arbitrary real additive constant is related to the well-known phenomenon that energy is undetermined to an arbitrary additive constant in physics (i.e., the zero of potential energy is not well-defined).

Substituting into Equation (229) yields

(232) |

Because this must hold for any initial state , we conclude that

(233) |

This equation can be integrated to give

(234) |

where use has been made of Equations (224) and (225). (Here, we assume that Hamiltonian operators evaluated at different times commute with one another.) The fact that \(H\) is undetermined to an arbitrary real additive constant leaves \(T\) undetermined to a phase-factor. Incidentally, in the above analysis, time is *not* an operator (we cannot observe time, as such), it is just a parameter (or, more accurately, a continuous label).

### Contributors

- Richard Fitzpatrick (Professor of Physics, The University of Texas at Austin)