9.1.2: Oscillations
-
- Last updated
- Save as PDF
Harmonic oscillation
The general form of a harmonic oscillation is: \(\Psi(t)=\hat{\Psi}{\rm e}^{i(\omega t\pm\varphi)}\equiv\hat{\Psi}\cos(\omega t\pm\varphi)\),
where \(\hat{\Psi}\) is the amplitude . A superposition of several harmonic oscillations with the same frequency results in another harmonic oscillation: \[\sum_i \hat{\Psi}_i\cos(\alpha_i\pm\omega t)=\hat{\Phi}\cos(\beta\pm\omega t)\] with:
\[\tan(\beta)=\frac{\sum\limits_i\hat{\Psi}_i\sin(\alpha_i)}{\sum\limits_i\hat{\Psi}_i\cos(\alpha_i)}~~~\mbox{and}~~~ \hat{\Phi}^2=\sum_i\hat{\Psi}^2_i+2\sum_{j>i}\sum_i\hat{\Psi}_i\hat{\Psi}_j\cos(\alpha_i-\alpha_j)\]
For harmonic oscillations: \(\displaystyle\int x(t)dt=\frac{x(t)}{i\omega}\) and \(\displaystyle\frac{d^nx(t)}{dt^n}=(i\omega)^n x(t)\).
Mechanic oscillation
For a spring with constant \(C\) and damping \(k\) which is connected to a mass \(M\), to which a periodic force \(F(t)=\hat{F}\cos(\omega t)\) is applied the equation of motion is \(m\ddot{x}=F(t)-k\dot{x}-Cx\). With complex amplitudes, this becomes \(-m\omega^2 x=F-Cx-ik\omega x\). With \(\omega_0^2=C/m\) it follows that:
\[x=\frac{F}{m(\omega_0^2-\omega^2)+ik\omega}~~,\mbox{and for the velocity:}~~ \dot{x}=\frac{F}{i\sqrt{Cm}\delta+k}\]
where \(\displaystyle\delta=\frac{\omega}{\omega_0}-\frac{\omega_0}{\omega}\). The quantity \(Z=F/\dot{x}\) is called the impedance of the system. The quality of the system is given by \(\displaystyle Q=\frac{\sqrt{Cm}}{k}\).
The frequency with minimal \(|Z|\) is called the velocity resonance frequency . This is equal to \(\omega_0\). In the resonance curve \(|Z|/\sqrt{Cm}\) is plotted against \(\omega/\omega_0\). The width of this curve is characterized by the points where \(|Z(\omega)|=|Z(\omega_0)|\sqrt{2}\). At these points: \(R=X\) and \(\delta=\pm Q^{-1}\), and the width is \(2\Delta\omega_{\rm B}=\omega_0/Q\).
The stiffness of an oscillating system is given by \(F/x\). The amplitude resonance frequency \(\omega_{\rm A}\) is the frequency where \(i\omega Z\) is a minimum. This is the case for \(\omega_{\rm A}=\omega_0 \sqrt{1-\frac{1}{2} Q^2} \).
The damping frequency \(\omega_{\rm D}\) is a measure for the time in which an oscillating system comes to rest. It is given by \(\displaystyle\omega_{\rm D}=\omega_0\sqrt{1-\frac{1}{4Q^2}}\). A weak damped oscillation \((k^2<4mC)\) dies out after \(T_{\rm D}=2\pi/\omega_{\rm D}\). For a critically damped oscillation \((k^2=4mC)\) \(\omega_{\rm D}=0\). A strong damped oscillation \((k^2>4mC)\) decays like (if \(k^2\gg 4mC\)) \(x(t)\approx x_0\exp(-t/\tau)\).
Electric oscillations
The impedance is given by: \(Z=R+iX\). The phase angle is \(\varphi:=\arctan(X/R)\). The impedance of a resistor is \(R\), of a capacitor \(1/i\omega C\) and of a self inductor \(i\omega L\). The quality of a coil is \(Q=\omega L/R\). The total impedance in case several elements are connected is given by:
-
Series connection: \(V=IZ\),
\[Z_{\rm tot}=\sum_i Z_i~,~~L_{\rm tot}=\sum_i L_i~,~~ \frac{1}{C_{\rm tot}}=\sum_i\frac{1}{C_i}~,~~Q=\frac{Z_0}{R}~,~~ Z=R(1+iQ\delta)\] -
Parallel connection: \(V=IZ\),
\[\frac{1}{Z_{\rm tot}}=\sum_i\frac{1}{Z_i}~,~~ \frac{1}{L_{\rm tot}}=\sum_i\frac{1}{L_i}~,~~ C_{\rm tot}=\sum_i C_i~,~~Q=\frac{R}{Z_0}~,~~ Z=\frac{R}{1+iQ\delta}\] Here, \(\displaystyle Z_0=\sqrt{\frac{L}{C}}\) and \(\displaystyle\omega_0=\frac{1}{\sqrt{LC}}\).
The power from a source is given by \(P(t)=V(t)\cdot I(t)\), so \(\left\langle P \right\rangle_t=\hat{V}_{\rm eff}\hat{I}_{\rm eff}\cos(\Delta\phi)\)
\(= \frac{1}{2} \hat{V}\hat{I}\cos(\phi_v-\phi_i)= \frac{1}{2} \hat{I}^2{\rm Re}(Z)= \frac{1}{2} \hat{V}^2{\rm Re}(1/Z)\), where \(\cos(\Delta\phi)\) is the work factor.
Waves in long conductors
If cables are used for signal transfer, e.g. coax cables then: \(\displaystyle Z_0=\sqrt{\frac{dL}{dx}\frac{dx}{dC}}\).
The transmission velocity is given by \(\displaystyle v=\sqrt{\frac{dx}{dL}\frac{dx}{dC}}\).
Coupled conductors and transformers
For two coils enclosing each others flux if \(\Phi_{12}\) is the part of the flux originating from \(I_2\) through coil 2 which is enclosed by coil 1, then \(\Phi_{12}=M_{12}I_2\), \(\Phi_{21}=M_{21}I_1\). The coefficients of mutual induction \(M_{ij}\) is given by:
\[M_{12}=M_{21}:=M=k\sqrt{L_1L_2}=\frac{N_1\Phi_1}{I_2}=\frac{N_2\Phi_2}{I_1}\sim N_1N_2\]
where \(0\leq k\leq1\) is the coupling factor . For a transformer \(k\approx1\). At full load:
\[\frac{V_1}{V_2}=\frac{I_2}{I_1}=-\frac{i\omega M}{i\omega L_2+R_{\rm load}}\approx-\sqrt{\frac{L_1}{L_2}}=-\frac{N_1}{N_2}\]
Pendulums
The oscillation time \(T=1/f\), for different types of pendulums is given by:
- Oscillating spring: \(T=2\pi\sqrt{m/C}\) if the spring force is given by \(F=C\cdot\Delta l\).
- Physical pendulum: \(T=2\pi\sqrt{I/\tau}\) with \(\tau\) the moment of force and \(I\) the moment of inertia.
- Torsion pendulum: \(T=2\pi\sqrt{I/\kappa}\) where \(\displaystyle\kappa=\frac{2lm}{\pi r^4\Delta\varphi}\) is the constant of torsion and \(I\) the moment of inertia.
- Mathematical pendulum: \(T=2\pi\sqrt{l/g}\) with \(g\) the acceleration of gravity and \(l\) the length of the pendulum.